![]() ![]() All adoption methods described in this article assume that your device is running in its factory default state.Once your UISP server is online/running, you may proceed with the methods in this article - Ubiquiti recommends using the UISP Mobile App for simplicity. To quickly set up the UISP Application using Ubiquiti's free cloud-hosted platform, please visit this link here. ![]() The following methods assume that you already have the UISP Application online/active, to which your device will adopt in order to become centrally-managed.Have you ever lost a manager or co-worker and felt like you lost an advocate? And if so, was it enough to make you want to leave the company where you were employed? Loss of an advocate was one of the reasons Leah White highlighted for seeking a new job. Nerd Journey # 213 - Advocacy Lost and Found with Leah White (2/2) Best Practices & General IT.I didn't know just how burned out I was!So, I've been deliberately NOT thinking about the IT side of things at my new comp. A couple of years ago I switched gears and got a job as a developer. Not an Admin anymore, but the job keeps following me IT & Tech Careers.In the spirit of fresh starts and new beginnings, weīegin another week with a collection of trivia to brighten up your Monday. Spring is here, the blossom is out and the sun is (sort-of) Spark! Pro Series - 17th April 2023 Spiceworks Originals.Hello EveryoneThank you for taking the time to read my post. I have three GS752TP-200EUS Netgear switches and I'm looking for the most efficient way to connect these together. I was planning to setup LAG between the three switches using the SFP ports to b. Most efficient way to connect three network switches Networking.I watched the video on it and it says the AP's are supposed to show up, but nothing does. I tried clicking Scan and typing the IP subnet.not sure. I tried running the discovery tool on the laptop, my desktop, and the controller server and it doesn't doesn't do anything. Its much easier to just plug in the factory default device, use Ubnt Discovery tool to set the inform to your remote hosted controller, and be done with it." Our firewall has multicast support disabled. 1st the right subnet, and then the 192.168 default IP subnet that factory default goes to. Seeing the tail log too, I saw it kept trying to contact the laptop's IP's. I can use the laptop as the controller again, but that's just doing what I was doing before. And of course, the controller doesn't see it.Default ssh pwd doesn't work: ubnt, and my former ssh pwd doesn't work- how am I supposed to set the inform-url?.Syswrapper.sh restore-default, it gets an IP on the right subnet (that's great right, supposedly), I think I've exhausted all possibilities here- I'm really not sure what to try next! Regardless, the other AP's have their inform url set to its IP- no big deal, I already tried that. I even have the AP set as the exact same IP as it used to be, and with the laptop as its controller, I was able to set the right dns settings as well, so it should see the controller's A record. Yet after hours of testing this, the controller still doesn't show the AP! Wireshark on the controller picks up TCP/HTTP traffic to the trouble AP- so they're communicating. ![]() But the controller's main IP is on another subnet- there's just a route to the other subnet.Ĭontroller is on 192, and wireless is on 10.0.Ĭontroller is able to ping all AP's.even the troublesome one. The thing is, when I use a laptop as the controller on the same subnet, it sees it. I also rebooted the controller last night. I tried every form of url I could think of, but set-inform does not work. I tried the DNS name, the IP, https/http, 8080, 8443. I did a set-inform for the troublesome AP. I was able to get the actual inform url by SSHing into another AP that is recognized by the controller. ![]()
0 Comments
Leave a Reply. |